smart-home

Tree: b31efd8359

Auteur	SHA1	Bericht	Datum
Bernd Gottschlag	08546c2e36	Re-enable dynamic packet length The nrf24l01 used on the boards is probably a counterfeit chip. It cannot acknowledge received packets (probably a bit flip of the NO_ACK bit described here: https://ncrmnt.org/2015/03/13/how-do-i-cost-optimize-nrf24l01/) if the dynamic packet length is disabled.	5 jaren geleden
Bernd Gottschlag	9694fa3913	Fix the rx0 address The address was set for the wrong address and thus the module could not receive acks from the base station	5 jaren geleden
Bernd Gottschlag	f78e2f65c6	Disable the dynamic packet length The packet length is now fixed to 32 bytes.	5 jaren geleden
Bernd Gottschlag	3a21aef881	Rework the makefile and optimize the code for flash space	5 jaren geleden
Bernd Gottschlag	30fe01bb9e	Generate an ID according to the dip switches The ID is used as the last byte of the RX address. It is also sent as a part of the data packet to allow assigning the sending station to a packet.	5 jaren geleden
Bernd Gottschlag	3dcfae6196	Change the way the TX and RX addresses are written to the nrf24l01	5 jaren geleden
Bernd Gottschlag	e7bfca4363	Use the IRQ signal from the nrf24l01 instead of polling the status This is done to avoid transmission erros as described in https://forum.mysensors.org/topic/10452/nrf24l01-communication-failure-root-cause-and-solution	5 jaren geleden
Bernd Gottschlag	204ff8d220	Add power save mode and send messages every 7.5s	5 jaren geleden
Bernd Gottschlag	0c03c24fcd	Change the MCU to the Atmega88 The pin definitions are updated and the uart debug interface is removed as it is not present on the actual board.	5 jaren geleden
Bernd Gottschlag	ddb5b0426e	Send the data from the BME280 with the NRF24L01	5 jaren geleden
Bernd Gottschlag	01dff7cfd3	Use spi functions	5 jaren geleden
Bernd Gottschlag	93fd7841a9	Use spi functions	5 jaren geleden
Bernd Gottschlag	9d1b611356	Use dedicated function to read the status register when transmitting	5 jaren geleden
Bernd Gottschlag	fc26a37348	Set the transmission retries and time-out duration to each maximum	5 jaren geleden
Bernd Gottschlag	b9cfc34e94	Flush TX FIFO after an unsuccessful transmission	5 jaren geleden
Bernd Gottschlag	e5ad15dbfa	Add reading from the BME280 using the official API Currently the data values are written to the debug output.	5 jaren geleden
Bernd Gottschlag	780cedcbc4	Fix order of the bit fields of the register definitions	5 jaren geleden
Bernd Gottschlag	278f7f23fe	WIP: use register definitions to access them	5 jaren geleden
Bernd Gottschlag	347211065c	Add prototyping code for sending a dummy message with the nrf24l01 The firmware is developed using an aduino micro pro with an atmega32u4 as the hardware for the weather station is not ready yet.	5 jaren geleden

19 Commits (b31efd8359f52defdca86bf99b44cc19c3b5b68d)