smart-home

ツリー: 608a6ee253

作成者	SHA1	メッセージ	日付
Bernd Gottschlag	3a21aef881	Rework the makefile and optimize the code for flash space	5年前
Bernd Gottschlag	30fe01bb9e	Generate an ID according to the dip switches The ID is used as the last byte of the RX address. It is also sent as a part of the data packet to allow assigning the sending station to a packet.	5年前
Bernd Gottschlag	3dcfae6196	Change the way the TX and RX addresses are written to the nrf24l01	5年前
Bernd Gottschlag	e7bfca4363	Use the IRQ signal from the nrf24l01 instead of polling the status This is done to avoid transmission erros as described in https://forum.mysensors.org/topic/10452/nrf24l01-communication-failure-root-cause-and-solution	5年前
Bernd Gottschlag	204ff8d220	Add power save mode and send messages every 7.5s	5年前
Bernd Gottschlag	0c03c24fcd	Change the MCU to the Atmega88 The pin definitions are updated and the uart debug interface is removed as it is not present on the actual board.	5年前
Bernd Gottschlag	ddb5b0426e	Send the data from the BME280 with the NRF24L01	5年前
Bernd Gottschlag	01dff7cfd3	Use spi functions	5年前
Bernd Gottschlag	93fd7841a9	Use spi functions	5年前
Bernd Gottschlag	9d1b611356	Use dedicated function to read the status register when transmitting	5年前
Bernd Gottschlag	fc26a37348	Set the transmission retries and time-out duration to each maximum	5年前
Bernd Gottschlag	b9cfc34e94	Flush TX FIFO after an unsuccessful transmission	5年前
Bernd Gottschlag	e5ad15dbfa	Add reading from the BME280 using the official API Currently the data values are written to the debug output.	5年前
Bernd Gottschlag	780cedcbc4	Fix order of the bit fields of the register definitions	5年前
Bernd Gottschlag	278f7f23fe	WIP: use register definitions to access them	5年前
Bernd Gottschlag	347211065c	Add prototyping code for sending a dummy message with the nrf24l01 The firmware is developed using an aduino micro pro with an atmega32u4 as the hardware for the weather station is not ready yet.	5年前

16 コミット (608a6ee253cea03a16aa168e3aa28b5827910a62)