smart-home

Koks: e435620c91

Autors	SHA1	Ziņojums	Datums
Bernd Gottschlag	e435620c91	Add a new packet format with the calculation of the CRC	5 gadus atpakaļ
Bernd Gottschlag	30fe01bb9e	Generate an ID according to the dip switches The ID is used as the last byte of the RX address. It is also sent as a part of the data packet to allow assigning the sending station to a packet.	5 gadus atpakaļ
Bernd Gottschlag	3dcfae6196	Change the way the TX and RX addresses are written to the nrf24l01	5 gadus atpakaļ
Bernd Gottschlag	e7bfca4363	Use the IRQ signal from the nrf24l01 instead of polling the status This is done to avoid transmission erros as described in https://forum.mysensors.org/topic/10452/nrf24l01-communication-failure-root-cause-and-solution	5 gadus atpakaļ
Bernd Gottschlag	f7bfdf101c	Add definitions of the IRQ pin to the nrf24l01	5 gadus atpakaļ
Bernd Gottschlag	1dd0f89149	Fix pin definitions of the interface to the nrf24l01	5 gadus atpakaļ
Bernd Gottschlag	204ff8d220	Add power save mode and send messages every 7.5s	5 gadus atpakaļ
Bernd Gottschlag	0c03c24fcd	Change the MCU to the Atmega88 The pin definitions are updated and the uart debug interface is removed as it is not present on the actual board.	5 gadus atpakaļ
Bernd Gottschlag	ddb5b0426e	Send the data from the BME280 with the NRF24L01	5 gadus atpakaļ
Bernd Gottschlag	33e1d5e700	WIP tidy up the NRF24L01 code	5 gadus atpakaļ
Bernd Gottschlag	347211065c	Add prototyping code for sending a dummy message with the nrf24l01 The firmware is developed using an aduino micro pro with an atmega32u4 as the hardware for the weather station is not ready yet.	5 gadus atpakaļ

11 Revīzijas (e435620c91f3540b90797058b142c81390adfc98)