smart-home

Drzewo: 9cc2488996

Autor	SHA1	Wiadomość	Data
Bernd Gottschlag	4f83ec8bef	Add handling of the salt On start-up the sensor sends a Get_Salt-message to the base station. The base station responds and sends the salt, which the sensor uses from there on.	5 lat temu
Bernd Gottschlag	1381cb6634	Add encryption for the sent packet	5 lat temu
Bernd Gottschlag	3a21aef881	Rework the makefile and optimize the code for flash space	5 lat temu
Bernd Gottschlag	8a49c011c9	Update packet protocoll	5 lat temu
Bernd Gottschlag	58a48e5230	Fix order of the element count and packet type bit field	5 lat temu
Bernd Gottschlag	e435620c91	Add a new packet format with the calculation of the CRC	5 lat temu
Bernd Gottschlag	30fe01bb9e	Generate an ID according to the dip switches The ID is used as the last byte of the RX address. It is also sent as a part of the data packet to allow assigning the sending station to a packet.	5 lat temu
Bernd Gottschlag	3dcfae6196	Change the way the TX and RX addresses are written to the nrf24l01	5 lat temu
Bernd Gottschlag	e7bfca4363	Use the IRQ signal from the nrf24l01 instead of polling the status This is done to avoid transmission erros as described in https://forum.mysensors.org/topic/10452/nrf24l01-communication-failure-root-cause-and-solution	5 lat temu
Bernd Gottschlag	f7bfdf101c	Add definitions of the IRQ pin to the nrf24l01	5 lat temu
Bernd Gottschlag	1dd0f89149	Fix pin definitions of the interface to the nrf24l01	5 lat temu
Bernd Gottschlag	204ff8d220	Add power save mode and send messages every 7.5s	5 lat temu
Bernd Gottschlag	0c03c24fcd	Change the MCU to the Atmega88 The pin definitions are updated and the uart debug interface is removed as it is not present on the actual board.	5 lat temu
Bernd Gottschlag	ddb5b0426e	Send the data from the BME280 with the NRF24L01	5 lat temu
Bernd Gottschlag	33e1d5e700	WIP tidy up the NRF24L01 code	5 lat temu
Bernd Gottschlag	347211065c	Add prototyping code for sending a dummy message with the nrf24l01 The firmware is developed using an aduino micro pro with an atmega32u4 as the hardware for the weather station is not ready yet.	5 lat temu

16 Commity (9cc24889966b95cd5c9c13676d2a8c6d2c5f410f)