smart-home

目錄樹: 4f83ec8bef

作者	SHA1	備註	提交日期
Bernd Gottschlag	4f83ec8bef	Add handling of the salt On start-up the sensor sends a Get_Salt-message to the base station. The base station responds and sends the salt, which the sensor uses from there on.	5 年之前
Bernd Gottschlag	608a6ee253	Fix generation of the salt	5 年之前
Bernd Gottschlag	1381cb6634	Add encryption for the sent packet	5 年之前
Bernd Gottschlag	8a49c011c9	Update packet protocoll	5 年之前
Bernd Gottschlag	e435620c91	Add a new packet format with the calculation of the CRC	5 年之前
Bernd Gottschlag	30fe01bb9e	Generate an ID according to the dip switches The ID is used as the last byte of the RX address. It is also sent as a part of the data packet to allow assigning the sending station to a packet.	5 年之前
Bernd Gottschlag	e7bfca4363	Use the IRQ signal from the nrf24l01 instead of polling the status This is done to avoid transmission erros as described in https://forum.mysensors.org/topic/10452/nrf24l01-communication-failure-root-cause-and-solution	5 年之前
Bernd Gottschlag	f1b0ebf618	Move SPI initialization and pin definitions to spi.c	5 年之前
Bernd Gottschlag	204ff8d220	Add power save mode and send messages every 7.5s	5 年之前
Bernd Gottschlag	0c03c24fcd	Change the MCU to the Atmega88 The pin definitions are updated and the uart debug interface is removed as it is not present on the actual board.	5 年之前
Bernd Gottschlag	ddb5b0426e	Send the data from the BME280 with the NRF24L01	5 年之前
Bernd Gottschlag	e5ad15dbfa	Add reading from the BME280 using the official API Currently the data values are written to the debug output.	5 年之前
Bernd Gottschlag	780cedcbc4	Fix order of the bit fields of the register definitions	5 年之前
Bernd Gottschlag	33e1d5e700	WIP tidy up the NRF24L01 code	5 年之前
Bernd Gottschlag	347211065c	Add prototyping code for sending a dummy message with the nrf24l01 The firmware is developed using an aduino micro pro with an atmega32u4 as the hardware for the weather station is not ready yet.	5 年之前

15 次程式碼提交 (4f83ec8bef0e9b452916519628fe3b2e18be7e00)