smart-home

Struktur: 3a21aef881

Autor	SHA1	Nachricht	Datum
Bernd Gottschlag	3a21aef881	Rework the makefile and optimize the code for flash space	vor 5 Jahren
Bernd Gottschlag	c86399b66e	Add the calculation of a crc The algorith used is for the CRC-16-CCITT, also known as CRC-KERMIT.	vor 5 Jahren
Bernd Gottschlag	30fe01bb9e	Generate an ID according to the dip switches The ID is used as the last byte of the RX address. It is also sent as a part of the data packet to allow assigning the sending station to a packet.	vor 5 Jahren
Bernd Gottschlag	e7bfca4363	Use the IRQ signal from the nrf24l01 instead of polling the status This is done to avoid transmission erros as described in https://forum.mysensors.org/topic/10452/nrf24l01-communication-failure-root-cause-and-solution	vor 5 Jahren
Bernd Gottschlag	0c03c24fcd	Change the MCU to the Atmega88 The pin definitions are updated and the uart debug interface is removed as it is not present on the actual board.	vor 5 Jahren
Bernd Gottschlag	5ee6bbbf1a	Add SPI interface functions	vor 5 Jahren
Bernd Gottschlag	e5ad15dbfa	Add reading from the BME280 using the official API Currently the data values are written to the debug output.	vor 5 Jahren
Bernd Gottschlag	33e1d5e700	WIP tidy up the NRF24L01 code	vor 5 Jahren
Bernd Gottschlag	347211065c	Add prototyping code for sending a dummy message with the nrf24l01 The firmware is developed using an aduino micro pro with an atmega32u4 as the hardware for the weather station is not ready yet.	vor 5 Jahren